<BGSOUND src="bikehorntoot.mp3">

After loaning out my Dynacord powered mixer to a friend he in turn loaned it to a fellow sound engineer (I use the term loosely!) Who managed to blow it up on a local UK Council paid job (Glossop Remembrance Sunday)! The story even made a local UK Councillor's Blog. The audience were as disappointed as myself I suspect! And being the kind guy that I am.. I'm only charging for the destroyed parts, including 20 power transistors! I suspect that most engineers would have written the unit of..

Update: Not only has the clown who used my mixer-amp without my permission and then broke it, not yet apologised to me. But I believe he has actually complained at the cost of the parts for the free repair! The cheek of it! I already explained about complementary transistors and the need to use a matching set. I may just send him a bill for labour: So far 6 hours at let's say 60 per hour = 360

All done!
1 x service manual 20
16 power transistors, silicon diode, 3 x resistors, solder and heat transfer paste 130.
Labour: 1 hour strip down time, 3 hours troubleshooting schematic, 2 hours fitting new parts,
2 hours following manufacturers service procedure and 1 hour rebuild = 9 hours @ 40 per hour 360.
Total 510. Be very grateful Coco!

A rather frazzled power amp section!

Transistors Removed

Removing Through-Hole components from a double sided circuit board takes time and care.

New power transistors fitted

Before soldering the transistors in I cleaned up the heat sinks with isopropol alcohol and then applied heat transfer compound to the bottom of each transistor.

Repaired and ready for 'Rasputin's Younger Brother'..

Share on Facebook! Share on Twitter! g+ Reddit Digg this story! Del.icio.us StumbleUpon

Articles in « Electronics »

You don't have permmission to comment, or comments have been turned off for this article.